Megger EVCA210-UK Electric Vehicle Charge Point Adapter
New electric vehicle charge point adapter
The Megger EVCA210/EVCA210-UK are compact, simple to use adapters designed to perform all the functions required by the electrical contractor to fully test Mode 3 AC Electric Vehicle Charge-points.
Specially designed to comply with UK, European and other International wiring regulations and standards, the Megger EVCA210/EVCA210-UK may be used on all single and three phase electric vehicle charge points, with appropriate connectors.
They are designed to test the function and safety of a charging point. The adapters allow you to conduct tests using appropriate single or multifunction test instruments (Megger MFT1741+) on EV charging points in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722. Charging points should be tested as part of the initial installation and repeated periodically.
| EVCA210 | EVCA210-UK | |
| Input voltage 250V (single phase system) / 430 V (three phase system) | YES | YES |
| Push Button for PE Pre-Test | YES | YES |
| Rotary switch providing PP State simulation | YES | YES |
| Rotary Switch providing CP State simulation | YES | YES |
| Push button for CP Error "E" simulation | YES | YES |
| Push button for PE Error (Earth Fault) simulation | YES | YES |
| Measurements on live conductors (L1, L2, L3 and N) and on PE conductor | YES | YES |
| Mains Socket: EVCA210-UK - 13A UK socket / EVCA210 - Schuko socket (CEE 7/3) | YES | YES |
| CP signal test, two 4 mm ports for connection to an oscilloscope | YES | YES |
| CAT II 300 V | YES | YES |
| IP Rating IP54 | YES | YES |
| Type 2 Plug for charging points with panel mounted socket outlet or fixed cable with vehicle connector. | YES | YES |
| Type 1 Plug for charging points with fixed cable and vehicle connector | NO | YES |
| Soft Carry Case | YES | YES |
What's in the box EVCA210-UK (UK Mains Socket):
- Megger Type 1 Charging Plug
- Megger Type 2 Charging Plug
- Soft Carry Case
- Instruction Manual
